Transferring The Drive Project - Siemens SINAMICS G130 Operating Instructions Manual

Commissioning
5.3 Procedure for commissioning via STARTER
5.3.3

Transferring the drive project

You have created a project and saved it to your hard disk. You now have to transfer your
project configuration data to the drive unit.
Specifying the online access point
To connect to the target system, the chosen access point must be specified.
In the menu bar, select Target system > Select target devices ...; the following dialog screen
appears.
Figure 5-33
The dialog screen lists all existing devices in the project.
162
Target device selection and access points
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A