List Of Signals For The Analog Signals - Siemens SINAMICS G130 Operating Instructions Manual

Parameter
• p4071
• p4073
• r4074
• p4076
• p4077
• p4078
• p4079
• p4080
8.2.1

List of signals for the analog signals

List of signals for the analog outputs
Table 8- 1 List of signals for the analog outputs
Signal
Speed setpoint before the setpoint filter
Motor speed unsmoothed
Actual speed smoothed
Output frequency
Output current
DC link voltage
Torque setpoint
Output power
For diagnostic purposes
Control deviation
Modulation depth
Torque-generating current setpoint
Torque-generating actual current
Flux setpoint
Actual flux
For further diagnostic purposes
Speed controller output
I component of speed controller
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
TM31 analog outputs, signal source
TM31 analog outputs, smoothing time constant
Analog outputs, actual output voltage/current
TM31 analog outputs, type
TM31 analog outputs, characteristic, value x1
TM31 analog outputs, characteristic, value y1
TM31 analog outputs, characteristic, value x2
TM31 analog outputs, characteristic, value y2
Parameters
r0060
r0061
r0063
r0066
r0068
r0070
r0079
r0082
r0064
r0074
r0077
r0078
r0083
r0084
r1480
r1482
8.2 TM31 analog outputs
Unit Scaling (100 %=...)
rpm p2000
rpm p2000
rpm p2000
Hz Reference frequency
Aeff p2002
V p2001
Nm p2003
kW r2004
rpm p2000
% Reference modulation depth
A p2002
A p2002
% Reference flux
% Reference flux
Nm p2003
Nm p2003
Output terminals
See table below
371