Communication Services And Used Port Numbers - Siemens SINAMICS G130 Operating Instructions Manual

Converter built-in units 75 kw-800 kw

Hide thumbs Also See for SINAMICS G130:

Table of Contents

6.12 Communication services and used port numbers

• p8920[0...239] PN Name of Station

• p8921[0...3]

• p8922[0...3]

• p8923[0...3

• p8940[0...239] CBE2x Name of Station

• p8941[0...3]

• p8942[0...3]

• p8943[0...3]

Faults and alarms

Communication services and used port numbers

The drive device supports the protocols listed in the following table. The address

parameters, the relevant communication layer as well as the communication role and the

communication direction are specified for each protocol.

This information allows you to match the security measures for the protection of the

automation system to the used protocols (e.g. firewall). As the security measures are limited

to Ethernet and PROFINET networks, no PROFIBUS protocols are listed in the table.

The following table shows the various layers and protocols that are used.

COMM BOARD state

PN IP address

PN default gateway

PN Subnet Mask

PN DHCP mode

PN interfaces configuration

CBE2x IP address

CBE2x Default Gateway

CBE2x Subnet Mask

CBE2x DHCP mode

CBE2x interfaces configuration

Fieldbus: Setpoint timeout

Modbus TCP connection interrupted

PN/COMM BOARD: Setpoint timeout

PN/COMM BOARD: No cyclic connection

Modbus TCP commissioning fault

Inverter chassis units

Operating Instructions, 07/2016, A5E00331449A