Simple Brake Control - Siemens SINAMICS G130 Operating Instructions Manual

Converter built-in units 75 kw-800 kw

Hide thumbs Also See for SINAMICS G130:

Table of Contents

Functions, monitoring, and protective functions

9.2 Drive functions

Simple brake control

The "Simple brake control" is used exclusively for the control of holding brakes. The holding

brake is used to secure drives against unwanted motion when deactivated.

The control command for releasing and applying the holding brake is transmitted directly to

the converter via DRIVE-CLiQ from the Control Unit, which logically combines the signals

with the system-internal processes and monitors these signals.

The converter then performs the action and controls the output for the holding brake

appropriately.

The operating principle of the holding brake can be configured using parameter p1215.

Commissioning parameter filter

IEC/NEMA mot stds

Unit system, motor equivalent circuit diagram data

Unit system selection

Technological unit selection

Technological unit reference variable

Reference speed reference frequency

Reference voltage

Reference current

Reference torque

Reference power

Reference angle

Reference temperature

Reference acceleration

Inverter chassis units

Operating Instructions, 07/2016, A5E00331449A