Basic Information About The Drive System - Siemens SINAMICS G130 Operating Instructions Manual

6.3

Basic information about the drive system

6.3.1 Parameters
Overview
The drive is adapted to the relevant drive task by means of parameters. Each parameter is
identified by a unique parameter number and by specific attributes (e.g. read, write, BICO
attribute, group attribute, and so on).
The parameters can be accessed via the following means:
● PC with the "STARTER" commissioning tool via PROFIBUS or PROFINET or via
Ethernet
● The user-friendly AOP30 Operator Panel
Parameter types
The following adjustable and display parameters are available:
● Adjustable parameters (write/read)
These parameters have a direct impact on the behavior of a function.
Example: Ramp-up and ramp-down time of a ramp-function generator
● Display parameters (read-only)
These parameters are used to display internal variables.
Example: current motor current
Figure 6-1
All these drive parameters can be read and changed via PROFIBUS or PROFINET using the
mechanisms defined in the PROFIdrive profile.
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
Parameter types
6.3 Basic information about the drive system
Operation
187