Siemens SINAMICS G130 Operating Instructions Manual page 213

Converter built-in units 75 kw-800 kw

Hide thumbs Also See for SINAMICS G130:

Table of Contents

Delivery condition

In the factory setting and after basic commissioning, an input voltage of 10 V is equal to the

main setpoint 100% reference speed (p2000), which has been set to the maximum speed

Example: Switching analog input 0 from voltage to current input 0 to 20 mA

Save changes so that they are protected against power failure

The change to the analog input must then be stored on the CompactFlash card so that it is

protected in the event of a power failure.

Inverter chassis units

Operating Instructions, 07/2016, A5E00331449A

Actual input voltage/current

Analog inputs smoothing time constant

Current referenced input value

Analog inputs type

Analog inputs, characteristic value x1

Analog inputs, characteristic value y1

Analog inputs, characteristic value x2

Analog inputs, characteristic value y2

Analog inputs offset

Current/voltage switchover

Set current/voltage selector to "Current" ("I").

Set analog input type 0 to 0 ... 20 mA.

6.5 Setpoint sources