Cu Terminals" Default Setting - Siemens SINAMICS G130 Operating Instructions Manual

Operation
6.4 Command sources
6.4.3

"CU terminals" default setting

Preconditions
● The Power Module and the Control Unit have been correctly installed.
● The "CU terminals" default setting was chosen during commissioning:
• STARTER (p0700):
• AOP30 (p0700):
Command sources
Figure 6-13
Priority
The command source priorities are shown in the diagram "Command sources AOP30 <->
CU terminals".
Note
LOCAL master control
All of the supplementary setpoints are deactivated for LOCAL master control.
208
"CU terminals"
"3: CU terminals"
Command sources AOP30 <-> CU terminals
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A