Siemens SINAMICS G130 Operating Instructions Manual page 153

⇒ To select a different predefined encoder configuration, check the Select standard encoder
from list radio button and select one of the encoders from the list.
⇒ To enter special encoder configurations, click the Enter data radio button and then the
Encoder data button. The following input screen is displayed for you to enter the required
data.
Figure 5-26 Entering encoder data – User-defined encoder data
⇒ Select the measuring system.
You can choose the following encoders in conjunction with SINAMICS G130:
● HTL
● TTL
⇒ Enter the required encoder data.
⇒ under the Details tab, special encoder properties can be set, for example, gear ratio, fine
resolution, inversion, measuring gear position tracking.
⇒ Click OK.
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
5.3 Procedure for commissioning via STARTER
Commissioning
153