Setting Application Macros; Setting Common Parameters; Restoring To Defaults - Siemens Sinamics V20 Operating Instructions Manual

3.2.3

Setting application macros

Functionality
This menu defines certain common applications. Each application macro provides a set of parameter settings for a specific
application. After you select an application macro, the corresponding settings are applied to the inverter to simplify the
commissioning process.
Application macro specific parameters
Parameter Description
P1080[0] Minimum frequency
P1300[0] Control mode
P1110[0] BI: Inhibit negative
frequency setpoint
P1200[0] Flying start
P1210[0] Automatic restart
P1120[0] Ramp-up time
P1121[0] Ramp-down time
P1312[0] Starting boost
P1311[0] Acceleration boost
P1310[0] Continuous boost
3.2.4

Setting common parameters

Parameter Description
P1080[0] Minimum motor frequency
P1082[0] Maximum motor frequency
P1120[0] Ramp-up time
P1121[0] Ramp-down time
P1058[0] JOG frequency
P1060[0] JOG ramp-up time
3.3

Restoring to defaults

Parameter Function
P0003 User access level
P0010 Commissioning parameter
P0970 Factory reset
After the setting for P0970, the inverter displays "8 8 8 8 8" and then the screen shows "P0970". P0970 and P0010 are
automatically reset to their original value 0.
16
Factory Default for application macro
default
AP010 AP020 AP021 AP030
0 15 20
0 7 7
0 1 -
0 - 2
1 2 2
10 10 10
10 10 20
0 - -
0 - -
50 -
Setting
= 1 (standard user access level)
= 30 (factory setting)
= 1: parameter reset to user defaults if stored, else factory
defaults (restoring to user defaults)
= 21: parameter reset to factory defaults deleting user defaults if
stored (restoring to factory defaults)
Remarks
- - Inverter running at a lower speed inhibited
0 1 =7: Quadratic V/f
=0: Linear V/f
=1: V/f with FCC
- - Reverse rotation inhibited
- - Search for the speed of the running motor
with a heavy inertia load so that the motor
runs up to the setpoint
- - Fault acknowledgement at power-on
10 5 Ramp-up time from zero to maximum
frequency
10 5 Ramp-down time from maximum frequency
to zero
30 30 Boost only effective when accelerating for
the first time (standstill)
0 - Boost only effective when accelerating or
braking
50 - Additional boost over the complete
frequency range
Parameter Description
P1001[0] Fixed frequency setpoint 1
P1002[0] Fixed frequency setpoint 2
P1003[0] Fixed frequency setpoint 3
P2201[0] Fixed PID frequency setpoint 1
P2202[0] Fixed PID frequency setpoint 2
P2203[0] Fixed PID frequency setpoint 3
Getting Started
A5E31842771, 02/2013