How To Set Up The Depth Output - Simrad ES70 - INSTALLATION REV A Installation Manual

5 In the
Select Inputs
to connect it.
This setting allows you to communicate with the motion sensor system.
The following proprietary telegram formats are supported:
• Sounder/TSS1 Motion protocol on page 173
• Simrad EM Attitude 1000 on page 168
• Simrad EM Attitude 3000 on page 169
6 Click to save the current settings and close the dialog.
OK
7 In the
I/O Setup
button to open the
In the
8
Serial Setup
9 Click to save the current settings and close the dialog.
OK
10 In the dialog, click on the chosen port to select it, then click the
I/O Setup
button to open the
In order to monitor the data flow, the motion sensor system must be active and
transmitting information to the ES70.
11 If the data flow is operational, close all dialogs.

How to set up the depth output

The ES70 Fish finding echo sounder will output depth information on several different
formats.
Supported telegram formats
• DBS Depth below surface on page 161
• DBT Depth below transducer on page 162
• DPT Depth on page 162
• Simrad EK500 Depth on page 167
• Atlas depth telegram on page 175
• PSIMDHB Bottom hardness and biomass on page 172
Wiring procedure for serial communication
1 Locate which RS-232 port you wish to use.
2 The ES70 Fish finding echo sounder, connect the transmit signal
on pin 5.
ground
→ Generic RS-232 Serial line on page 42
3 On the remote system, wire as described in the relevant documentation.
4 Ensure that the length of the cable does not exceed approximately 50 meters. If a
longer cable is required, you may need to use buffer amplifiers on the serial line.
343522/A
dialog, locate the
AML
dialog, click on the chosen port to select it, then click the
dialog.
Serial Setup
dialog, enter the relevant parameters to set up the port.
dialog.
Port Monitor
Interfaces and integration
on the left side, and click the [>] button
Setup
Monitor
on pin 3, and
Tx
93