How To Set Up The Depth Output - Simrad ES70 - REFERENCE MANUAL REV A Reference Manual

• Simrad EM Attitude 1000 on page 196
• Simrad EM Attitude 3000 on page 197
Click to save the current settings and close the dialog.
6
OK
7 In the
I/O Setup
button to open the
8 In the
Serial Setup
9 Click to save the current settings and close the dialog.
OK
10 In the dialog, click on the chosen port to select it, then click the
I/O Setup
button to open the
In order to monitor the data flow, the motion sensor system must be active and
transmitting information to the ES70.
11 If the data flow is operational, close all dialogs.

How to set up the depth output

The ES70 Fish finding echo sounder will output depth information on several different
formats.
Supported telegram formats
• DBS Depth below surface on page 190
• DBT Depth below transducer on page 190
• DPT Depth on page 190
• Simrad EK500 Depth on page 195
• Atlas depth telegram on page 203
• PSIMDHB Bottom hardness and biomass on page 200
Wiring procedure for serial communication
1 Locate which RS-232 port you wish to use.
2 The ES70 Fish finding echo sounder, connect the transmit signal
on pin 5.
ground
3 On the remote system, wire as described in the relevant documentation.
Ensure that the length of the cable does not exceed approximately 50 meters. If a
4
longer cable is required, you may need to use buffer amplifiers on the serial line.
Setup procedure
1 Click the icon under the
Setup
Click
2
Depth Output
338106/A
dialog, click on the chosen port to select it, then click the
dialog.
Serial Setup
dialog, enter the relevant parameters to set up the port.
dialog.
Port Monitor
menu to open the
Main
to open the
Depth Output
Operational procedures
Tx
sub-menu.
Setup
dialog.
Setup
Monitor
on pin 3, and
95