Split Beam Transducer To Single Beam Transceiver - Simrad ES70 - INSTALLATION REV A Installation Manual

Simrad ES70

Split beam transducer to single beam transceiver

This is the termination of the transducer cable from a single frequency, split beam
transducer - wired as a single beam transducer - to the socket on the General Purpose
Transceiver Unit (GPT). The other end of the cable is permanently fixed to the transducer.
If you need to splice the transducer cable, it is very important to use the correct cable,
and to avoid ground loops. We strongly recommend the use of a junction box. We also
recommend that you install the transducer cable in a steel conduit.
For more information, see:
• Transducer cable splicing on page 142
• Steel conduit on page 142
• GPT Transducer plug connection on page 107
68
343522/A