LOCKNUT
REAR
MOUNTING
BRACKET
i^^&J
// / ADJUSTMENT
« J tl •H^//r»<> BRACKET
PUMP
^
SPACER
ADJUSTMENT
HOLE
FRONT
MOUNTING
BRACKET
PIVOT
BOLTS
90308
Fig. 1C-18 Four-Cylinder Engine Power Steering Pump
Drive Belt Adjustment
(a) Loosen alternator pivot and adjusting bolts.
(b) Tighten belt with pry bar. Pry on alternator
front housing only.
(c) Tighten adjusting bolt with 18 foot-pounds
(24 N«m) torque. Tighten pivot bolt with 28 foot-pounds
(38 N»m) torque.
(d) Re-test tension.
Fig. 1C-19 Six-Cylinder Engine (w/o A/C)
Alternator Drive Belt Adjustment
•i
ADJUSTING
SCREW
COOLING SYSTEMS 1C-25
Fig. 1C-20 Eight-Cylinder Engine Alternator Drive Belt Adjustment
Alternator and Fan (Six-Cylinder Engine with Air Conditioner)
(1) Position Tension Gauge J-23600 or J-29550 on
section of belt adjacent to inner fender panel. Test belt
tension according to manufacturer's instructions.
(2) Adjust belt tension to specification if less than
90 pounds-force (400 N).
(3) Adjustment (fig. 1C-21).
(a) From underside of engine compartment,
loosen lower mounting bracket pivot nut and adjusting
bolt.
(b) Insert pry bar into hole in bottom of bracket
and pry to tighten belt.
(c) Tighten adjusting bolt with 18 foot-pounds
(24 N«m) torque. Tighten pivot nut with 28 foot-pounds
(38 N»m) torque.
(d) Re-test tension.
Fig. 1C-21
Six-Cylinder Engine (w/A/C)
Alternator Drive Bslt Adjustment