Subaru Legacy 2004 Service Manual page 2401

16) Lower the transmission jack.
NOTE:
Do not separate the transmission jack and trans-
mission.
17) Remove the oil charge pipe. <Ref. to 5AT-70,
REMOVAL, Oil Charge Pipe.>
18) Remove the ATF cooler inlet and outlet pipes.
NOTE:
When removing the outlet pipe, be careful not to
lose the ball and spring used with retaining screw.
19) Disconnect the connector from turbine speed
sensor 1.
20) Remove the rear vehicle speed sensor.
21) Remove the oil pan.
22) Disconnect the control valve connector and
front vehicle speed sensor connector.
(A)
(A) Control valve connector
(B) Front vehicle speed sensor connector
Rear Vehicle Speed Sensor
AT-01387
AT-01950
(B)
AT-01956
5AT-55
AUTOMATIC TRANSMISSION
23) Remove the control valve body.
24) Remove the bolt securing harness of transmis-
sion main case.
25) Remove the harness assembly.
B: INSTALLATION
1) Pass the harness assembly through the hole in
transmission case.
2) Install the securing bolt of transmission main
case.
Tightening torque:
$
7 N m (0.7 kgf-m, 5.2 ft-lb)
AT-01957
AT-02035
AT-00048
AT-02035