Subaru Legacy 2004 Service Manual page 2416

AUTOMATIC TRANSMISSION
4) Install the ATF cooler hoses and pipes.
5) Connect the engine harness connectors, and
then install the engine hanger rear.
6) Install the oil charge pipe. <Ref. to 5AT-70, IN-
STALLATION, Oil Charge Pipe.>
7) Install the resonator chamber.
<Ref. to IN(H6DO)-9, INSTALLATION, Resonator
Chamber.>
8) Install the air intake chamber.
<Ref. to IN(H6DO)-7, INSTALLATION, Air Intake
Chamber.>
9) Lift-up the vehicle.
10) Install the pipe securing bolts on the side of
transmission.
11) Install the union screw of oil cooler inlet and
outlet pipes.
Tightening torque:
!
T1: 25 N m (2.5 kgf-m, 18.1 ft-lb)
!
T2: 44 N m (4.5 kgf-m, 32.5 ft-lb)
ATF Cooler Pipe & Hose
12) Install the inlet and outlet pipes of the ATF oil
cooler hose to oil cooler pipe.
AT-02030
13) Install the front exhaust pipe.
<Ref. to EX(H6DO)-6, INSTALLATION, Front Ex-
haust Pipe.>
C: INSPECTION
Repair or replace any defective hoses, pipes,
clamps, and washers found from the inspection be-
low.
1) Check for ATF leaks in joints between the trans-
mission, radiator, pipes, and hoses.
2) Check for deformed clamps.
3) Lightly bend the hose and check for cracks in the
surface and other damages.
4) Pinch the hose with your fingers and check for
poor elasticity. Also check for poor elasticity in the
parts where the clamp was installed by pressing
with your fingernail.
5) Check for peeling, cracks, and deformation at
the tip of the hose.
6) Check the ATF cooler for cracks or deformation.
(ATF cooler model with warmer function)
AT-02028
AT-02029
5AT-68
AT-02027