Subaru Legacy 2004 Service Manual page 2386

AUTOMATIC TRANSMISSION
26) Remove the transmission mounting bolt (upper
side).
27) Lift-up the vehicle. (Turbo model)
28) Remove the under cover. (Turbo model)
29) Remove the center exhaust pipe, rear exhaust
pipe and muffler. (Turbo model) <Ref. to
EX(H4DOTC)-6, REMOVAL,
Pipe.> <Ref. to EX(H4DOTC)-11, REMOVAL,
Rear Exhaust Pipe.> <Ref. to EX(H4DOTC)-12,
REMOVAL, Muffler.>
30) Remove the front exhaust pipe, rear exhaust
pipe and muffler. (Non-turbo model) <Ref. to
EX(H6DO)-5, REMOVAL, Front Exhaust Pipe.>
<Ref. to EX(H6DO)-8, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H6DO)-10, REMOVAL, Muf-
fler.>
31) Remove the heat shield cover.
32) Remove the ATF drain plug to drain ATF.
(B)
(A) Oil pan
(B) Drain plug
Automatic Transmission Assembly
AT-00106
Center Exhaust
AT-01331
(A)
AT-01361
5AT-40
33) Remove the oil charge pipe.
34) Disconnect the connector from turbine speed
sensor 1.
35) Remove the turbine speed sensor 1 connector
mounting bolt and rotate the sensor by 180%.
CAUTION:
Failure to follow this procedure may cause the
interference between vehicle body and sensor
while removing/installing transmission, result-
ing in damage.
36) Remove the propeller shaft. <Ref. to DS-10,
REMOVAL, Propeller Shaft.>
37) Remove the shift select cable. <Ref. to CS-12,
REMOVAL, Select Cable.>
AT-01371
AT-01642
AT-01640