Subaru Legacy 2004 Service Manual page 2394

AUTOMATIC TRANSMISSION
2. TRANSMISSION REAR CROSSMEMBER
& REAR CUSHION RUBBER
1) Install the rear cushion rubber.
Tightening torque:
$
35 N m (3.6 kgf-m, 26 ft-lb)
2) Install the crossmember.
Tightening torque:
$
70 N m (7.1 kgf-m, 51.6 ft-lb)
3) Remove the transmission jack.
4) Install the heat shield cover.
5) Install the center exhaust pipe, rear exhaust pipe
and muffler. (Turbo model)
<Ref. to EX(H4DOTC)-7, INSTALLATION, Center
Exhaust Pipe.> <Ref. to EX(H4DOTC)-11, IN-
STALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H4DOTC)-12, INSTALLATION, Muffler.>
6) Install the front exhaust pipe, rear exhaust pipe
and muffler. (Non-turbo
EX(H6DO)-6, INSTALLATION, Front Exhaust
Pipe.> <Ref. to EX(H6DO)-8, INSTALLATION,
Rear Exhaust Pipe.> <Ref. to EX(H6DO)-10, IN-
STALLATION, Muffler.>
7) Connect the battery ground cable to battery.
C: INSPECTION
Repair or replace parts if the results of the inspec-
tion below are not satisfied.
1. PITCHING STOPPER
Check pitching stopper for bends or damage. En-
sure there are no cracks, hardening or damage on
rubbers.
2. TRANSMISSION REAR CROSSMEMBER
& REAR CUSHION RUBBER
Check the crossmember for bends or damage. En-
sure there are no cracks, hardening, or damage on
cushion rubbers.
Transmission Mounting System
AT-01377
model) <Ref. to
5AT-48