Subaru Legacy 2004 Service Manual page 2389

12) Install the pitching stopper.
Tightening torque:
$
T1: 50 N m (5.1 kgf-m, 36.9 ft-lb)
$
T2: 58 N m (5.9 kgf-m, 42.8 ft-lb)
T2
13) Lift-up the vehicle.
14) Replace the front differential side retainer oil
seal.
(1) Remove the oil seal by using flat tip screw-
driver and etc.
(2) Fit a new oil seal using ST.
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
NOTE:
• Apply oil to the oil seal lips.
• Always replace the differential side oil seal after
extracting front drive shaft from the transmission.
15) Apply grease to the oil seal lips.
16) Set the ST to the side retainer.
ST 28399SA000 OIL SEAL PROTECTOR
ST
Automatic Transmission Assembly
T1
AT-01380
AT-01378
AT-00110
5AT-43
AUTOMATIC TRANSMISSION
17) Install the front drive shaft into transmission.
NOTE:
Replace the circlip of drive shaft with a new one.
18) Install the front drive shaft into transmission, re-
move the ST and insert the drive shaft securely.
ST 28399SA000 OIL SEAL PROTECTOR
19) Install the ATF cooler inlet and outlet pipes.
(Non-turbo model) <Ref. to 5AT-66, INSTALLA-
TION, ATF Cooler Pipe & Hose.>
20) Install the ATF cooler bracket to transmission
proper. (ATF cooler model with warmer function)
Tightening torque:
$
25 N m (2.5 kgf-m, 18.1 ft-lb)
• Non-turbo model
21) Install the inlet and outlet hoses to the ATF inlet
and outlet pipes.
22) Insert the ball joint into housing.<Ref. to FS-17,
INSTALLATION, Front Ball Joint.>
23) Install the front stabilizer bracket. <Ref. to FS-
16, INSTALLATION, Front Stabilizer.>
AT-02034
AT-01390