Subaru Legacy 2004 Service Manual page 2407

19.Transmission Control Mod-
ule (TCM)
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the lower cover and then disconnect
the connector.
3) Remove the body integrated unit. (RHD model)
<Ref. to SL-46, REMOVAL, Body Integrated Unit.>
4) Disconnect the connector from TCM.
• RHD model
(A)
• LHD model
(A)
(A) Transmission control module (TCM)
(B) Steering column
5) Remove the relay from TCM body.
6) Remove the TCM.
B: INSTALLATION
1) Install the relay to TCM body.
2) Install the TCM.
Tightening torque:
$
7.5 N m (0.76 kgf-m, 5.5 ft-lb)
Transmission Control Module (TCM)
(B)
AT-01342
(B)
AT-02026
5AT-61
AUTOMATIC TRANSMISSION
• RHD model
(A)
• LHD model
(A)
(A) Transmission control module (TCM)
(B) Steering column
3) Connect the connector to TCM.
4) Install in the reverse order of removal.
5) Perform the Clear Memory 2. <Ref. to 5AT(di-
ag)-18, CLEAR MEMORY MODE, OPERATION,
Subaru Select Monitor.>
(1) Connect the Subaru Select Monitor to data
link connector.
(2) Turn ignition switch to ON (engine OFF) and
turn Subaru Select Monitor switch to ON.
(3) Ensure that the select lever is in "P" range.
(4) On the «Main Menu» display screen, select
the {Each System Check} and press the [YES]
key.
(5) On the «System Selection Menu» display
screen, select the {Transmission} and press the
[YES] key.
(6) Press the [YES] key after the information of
transmission type has been displayed.
(7) On the «Transmission Diagnosis» display
screen, select the {Clear Memory 2} and press
the [YES] key.
6) Perform the inspection with driving the vehicle at
the end of repair work, and make sure there is no
faulty as below;
• Excessive shift shock
• Oil leakage from transmission proper and etc.
• Occurrence of noise caused by interference etc.
(B)
AT-01342
(B)
AT-02026