Subaru Legacy 2004 Service Manual page 2382

AUTOMATIC TRANSMISSION
8. Transfer Clutch Pressure
Test
A: INSPECTION
1) Lift-up the vehicle.
2) Remove the heat shield cover securing bolts to
slide the heat shield cover.
3) Remove the test plug and install the ST.
ST 498897200 OIL PRESSURE ADAPTER
CAUTION:
Be careful not to cut your arm with the heat
shield cover when removing the test plug and
installing the ST.
4) Set the ST1 and ST2.
ST1 498897200 OIL PRESSURE ADAPTER
ST2 498575400 OIL PRESSURE GAUGE
ASSY
5) Lower the vehicle, and pull the ST1 and ST2 into
vehicle.
ST1 498897200 OIL PRESSURE ADAPTER
ST2 498575400 OIL PRESSURE GAUGE
ASSY
Transfer Clutch Pressure Test
AT-01754
AT-01755
AT-01756
5AT-36
6) Connect the Subaru Select Monitor to data link
connector and read the current data. <Ref. to
5AT(diag)-16, READ CURRENT DATA, OPERA-
TION, Subaru Select Monitor.>
(1) Start the engine.
(2) Turn the Subaru Select Monitor switch to
ON.
(3) On the «Main Menu» display screen, select
the {Each System Check} and press the [YES]
key.
(4) On the «System Selection Menu» display
screen, select the {Transmission} and press the
[YES] key.
(5) Press the [YES] key after the information of
transmission type has been displayed.
(6) On the «Transmission Diagnosis» display
screen, select the {Current Data Display/Save},
and then press the [YES] key.
(7) On the «Transmission Diagnosis» display
screen, select the {Data Display} and press the
[YES] key.
(8) Using the scroll key, display the "T/F sole-
noid target oil pressure".