Subaru Legacy 2004 Service Manual page 2383

7) Perform the transfer clutch pressure test.
NOTE:
• Do not perform the transfer clutch pressure test for more than 5 seconds at a time. It makes engine oil and
ATF deteriorate and the clutch and brake to be adversely affected.
• Be sure to cool down the engine for at least one minute with the select lever set in "P" or "N" range and with
the idle speed lower than 1,200 rpm after performing transfer clutch pressure test.
• Adjust the throttle valve angle in order to obtain the "T/F solenoid target pressure" displayed on the Subaru
Select Monitor.
Range of the Throttle valve
selector lever angle
Full open
D
Partial throttle
N Full closed
Transfer Clutch Pressure Test
"T/F Solenoid Target Pressure"
ATF temperature displayed on the Subaru Select
condition
45 — 55%C
(104 — 131 %F)
5AT-37
AUTOMATIC TRANSMISSION
Monitor
kPa
900
(8.16 — 9.33, 116.0 — 132.7)
500
(4.08 — 5.46, 58.0 — 77.6)
0
Standard line pressure
2
kPa (kg/cm , psi)
800 — 915
400 — 535
0 — 50
(0 — 0.51, 0 — 7.3)