Subaru Legacy 2004 Service Manual page 2430

AUTOMATIC TRANSMISSION
31.Parking Pawl
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 5AT-38, REMOVAL, Automatic Trans-
mission Assembly.>
2) Remove the extension case and intermediate
case. <Ref. to 5AT-72, REMOVAL, Extension
Case & Intermediate Case.>
3) Remove the center differential carrier. <Ref. to
5AT-80, REMOVAL, Center Differential Carrier.>
4) Remove the parking support actuator.
5) Remove the parking pawl, parking pawl shaft
and return spring.
B: INSTALLATION
1) Set the transmission to "N" range.
2) Install the parking pawl, parking pawl shaft and
return spring.
3) Temporarily secure the parking support actua-
tor.
Parking Pawl
4) Set the ST between parking pawl and parking
support actuator.
ST 18679AA000 ADJUSTER
5) Tighten the securing bolts while pressing park-
ing support actuator with finger.
Tightening torque:
%
10
CAUTION:
Press the reduction driven gear and parking
pawl in bottom condition.
AT-02067
6) Using the ST, tighten the bolts which tightened in
step 4) with specified angle.
AT-02068
Tightening angle:
&%
18
ST 18554AA000 ANGLE GAUGE
AT-02068
5AT-82
ST
! %
2 N m (1.0 0.2 kgf-m, 7.4
ST
&
2
AT-02069
%
1.5 ft-lb)
AT-02070