Toyota Camry Manual page 1058

1 Connect OBD II scan tool or TOYOTA hand–held tester, and read value of man-
ifold absolute pressure.
PREPARATION:
(a) Connect the OBD II scan tool or TOYOTA hand–held tester to the DLC3.
(b) Turn the ignition switch ON and push the OBD II scan tool or TOYOTA hand–held tester main switch
ON.
CHECK:
Read value of the manifold absolute pressure on the OBD II scan tool or TOYOTA hand–held tester.
OK:
Same as atmospheric pressure.
NG
2 Check voltage between terminals VC and E2 of ECM connector.
ON
w/o Immobiliser
E2 (–)
w/ Immobiliser
E2 (–)
BE6653
P23721
A03008
OK
DIAGNOSTICS
OK
PREPARATION:
(a) Remove the glove compartment (See page SF–64).
(b) Turn the ignition switch ON.
CHECK:
Measure voltage between terminals VC and E2 of the ECM
connector.
OK:
Voltage: 4.5 – 5.5 V
VC (+)
NG
VC (+)
A03407
– ENGINE (5S–FE)
Check for intermittent problems
(See page DI–3).
Check and replace ECM (See page IN–31).
Author :
DI–31
Date :
266