Toyota Camry Manual page 963

CO–8
3
1
2
COOLING (5S–FE)
INSTALLATION
1.
Install a new gasket and the water pump with the 3 bolts.
N00918
2.
Connect
(a)
(b)
(c)
(d)
S06015
(e)
Z19283
(f)
S05924
3.
(a)
(b)
(c)
4.
5.
S05599
– WATER PUMP
INSTALL WATER PUMP TO WATER PUMP COVER
Torque: 8.8 N·m (90 kgf·cm, 78 in.·lbf)
INSTALL WATER PUMP AND WATER PUMP COVER
ASSEMBLY
Install new O–ring and gasket to water pump cover.
Install a new O–ring to the water bypass pipe.
Apply soapy water to the O–ring on the water bypass
pipe.
Connect the water pump cover to the water bypass pipe.
Do not install the nuts yet.
Install the water pump with the 3 bolts. Tighten the bolts
in the sequence shown.
Torque: 8.8 N·m (90 kgf·cm, 78 in.·lbf)
Install the 2 nuts holding the water pump cover to the wa-
ter bypass pipe.
Torque: 9.3 N·m (95 kgf·cm, 82 in.·lbf)
INSTALL GENERATOR DRIVE BELT ADJUSTING BAR
Install the adjusting bar with the bolt.
Torque: 22 N·m (224 kgf·cm, 16 ft·lbf)
Install the engine wire clamp to the adjusting bar.
Install the crankshaft position sensor connector to the
bracket on the adjusting bar.
w/ Oil Cooler:
INSTALL A/C COMPRESSOR (See page EM–75)
INSTALL NO.2 IDLER PULLEY (See page EM–23)
Author :
CO06B–03
Date :
1582