BIO RAD ZE5 User Manual page 266

Cell analyzer and everest software
Table of Contents

Advertisement

Chapter 7 Creating Experiments and Workspaces
6.
Using the Selected Fluorophores, Plate Setup, and Sample Naming panels, configure the new
panel as needed.
Note: If settings for the new panel need to differ from settings for the previous panel, ensure
that you change them.
7.
Click the Next arrow to go to the Settings screen. Note the names of the panels in the bottom
navigation panel on the screen.
8.
Draw plots and regions and create gates for the new panel.
9.
Click Apply to apply the experiment, including all of the panels, to the workspace.
When you move to Acquisition mode, the ZE5 Cell Analyzer will acquire the whole plate or set of
tubes in a single run and will respect the settings adjustments optimized for each panel in Setup
mode; there is no need to reoptimize settings between the panel runs.
To adjust settings in a multipanel experiment
u
Click the panel's name in the bottom navigation bar in the Setup screen.
The details for the selected panel appear in the Plate Settings panel.
264 | ZE5 Cell Analyzer and Everest Software

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZE5 and is the answer not in the manual?

Table of Contents

Save PDF