Connecting External Waste; Specifying External Port Use - BIO RAD ZE5 User Manual

Cell analyzer and everest software
Table of Contents

Advertisement

Connecting External Waste

When the instrument is connected to an external waste line and is put into external waste mode, waste
enters the top waste bottle and drains from there into the external waste line. The bottom waste bottle
is not used in this mode.
Caution: Biohazard! Only Bio-Rad Service personnel are permitted to install the
External Waste kit and connect the ZE5 Cell Analyzer to external DI water or waste
lines. The waste contains samples that are run through the instrument and thus could
contain biohazardous materials. Consult with your local safety officer or review local
state and federal regulations to ensure proper handling and disposal of biohazardous
substances.

Specifying External Port Use

After the instrument has been connected to an external DI water or waste line, a Bio-Rad service
engineer must configure your system to use the external port.
Connecting External Waste
User Guide | 381

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZE5 and is the answer not in the manual?

Table of Contents

Save PDF