Ricoh Neptune-P1 Service Manual page 52

Roll Feeder (B852)
1
2. Remove the screws from the top cover [1] and slide it to the rear (do not disconnect and remove it)
( x 6).
3. Set the level [2] in the center as shown and read its gauge.
4. Set the shoes , , , under each corner of the main machine.
5. Use a wrench to adjust the nuts [1] of each foot to raise or lower the main machine at each corner.
• The main machine must be level side-to-side within ±0.15/m.
6. Attach the left leg cover [2] and the right leg cover [3].
51