Ricoh Neptune-P1 Service Manual page 60

3. Position the left exit guide plate [2] as shown, then attach it with its magnet.
4. Do a test print to confirm that the paper exits the main machine straightly and smoothly between the
guide plates.
Entering the Cut Length Adjustment
1. Do the settings for SP1920. These are the cut length SP settings for the rolls (there are two settings for
each roll).
2. Check the label on the right side of the roll feeder drawer. Do the settings written on the label.
Roll SP No.
Roll 1 1920-111
Roll 1 1920-115
Roll 2 1920-211
Roll 2 1920-215
1. Switch the main power switch off, then switch it on again.
Setting Paper Sizes/Types for the Tray 1 (1st Roll), Tray 2 (2nd Roll)
1. [Menu].
2. []> "Paper Input"> [OK]
3. []> "Paper Size"> "Paper Size: Tray 1"> [OK]
Cut Length Adjustment: 1st Roll:297 mm:Plain Paper
Cut Length Adjustment: 1st Roll:1189 mm:Plain Paper
Cut Length Adjustment: 2nd Roll:297 mm:Plain Paper
Cut Length Adjustment: 2nd Roll:1189 mm:Plain Paper
Name
Roll Feeder (B852)
1
59