Ricoh Neptune-P1 Service Manual page 280

1 Image Area
2 IDPtrn:LDuty
3 IDPtrn:HDuty
4 Copy Jobs
2207 Force Tnr
Push [Execute] to force toner supply. Make a copy and check the image density. This SP
supplies more toner to make light copies darker. Each time this SP is done, toner is supplied
one time.
2208 Tnr S Set
1 Gain
Toner Supply
3
Mode
2301 TrCurr Adj
Use these SP's to adjust the coefficient and power output used to develop the image at the
center, leading edge, and trailing edge.
ID Sensor Pattern: Low Duty Copy
Jobs
ID Sensor Pattern: High Duty
Copy Jobs
Toner Supply Setting
Sets the toner supply capacity for the job load.
[0 to 3/1/1]
0: L (Low)
1: M (Medium)
2: H (High)
3: HH (Very High)
Sets the toner supply mode.
0: Detect Mode (uses ID sensor)
1: Fixed Mode
• If the ID sensor is damaged and cannot be replaced immediately,
set this SP to "1". The operator can continue to use the machine
until a new ID sensor becomes available.
• After the ID sensor has been replaced, reset this SP to 0.
Transfer Current Adjustment
[-56 to -952/-650/1 V step]
[-56 to -952/-414/1 V step]
[56 to 952/453/1 V step]
[0 to 1/0/1]
0: Low Duty Mode
1: High Duty Mode
Forced Toner Supply
SP2-xxx Drum
5
279