Ricoh Neptune-P1 Service Manual page 269

5. Service Tables
This SP sets the temperature at which inching starts in a low-temperature environment where
fusing temperature control is handled with the settings of SP1937.
[0 to 50/20/5]
11 LTemp:Cold1
If the hot roller temperature is below the temperature set with this SP at the beginning of a cold
start, the machine determines that it is in a low temperature environment
[0 to 50/15/1]
12 LTemp:Cold2
This SP determines the length of time the machine remains in the low temperature cold start
mode after the machine determines that that it has been cold started in a low temperature
environment. After this time has elapsed, fusing temperature control will operate with the paper
type and thickness settings (see "Paper Thickness Default Selection" in this section).
5
[0 to 20/7/0.5 min.]
13 LTemp:Int
This SP sets the size of the gap between sheets of paper while the machine is in the low
temperature environment cold start mode.
[1 to 10/3/0.1 mm]
1938 PreFB Step
This SP switches step control by width on and off. After this SP has been switched on, the step
control by width can be set up with SP1939 002 to 004.
Note:
• These settings can be done for each paper type and thickness mode.
• Modes "1" to "5" below refer to the paper and thickness settings selected in User Tools
1 Plain: Mode1
2 Plain: Mode2
3 Plain: Mode3
4 Plain: Mode4
5 Plain: Mode5
6 Trans.: Mode1
268
Low Temp Mode Setting: Cold Start
Low Temp Mode Setting: Cold Start Hold Time
Low Temp Mode Paper Interval Ratio
Pressure Roller Feedback Control Step Width Switch
(see "Paper Thickness Default Selection" in this section).
[0 to 1/0/1]
0: Disable
1: Enable