3. Replacement and Adjustment
SP Adjustments
Image Adjustment with SP Codes
Do the adjustments described in this section if printing is not satisfactory.
• Before doing any adjustments, read the section below so that you know how to print the test patterns.
• Do each adjustment in the order described below (Steps 1 to 4).
3
• Always turn the machine power off/on after each SP adjustment to enable the new setting.
• Before you start measurements and adjustments, let the test print output cool for five minutes.
How to Print Test Patterns
Before you can do any adjustments, you must know how to print the test patterns.
1. Enter the SP mode: []*[] for 3 sec.> [OK].
2. [OK]> [OK]> "Bit Switch"
3. [] x4 times> "1301 Adjustment Sheet"
180