Ricoh Neptune-P1 Service Manual page 186

SP Set To:
2101-1
2101-2
2101-3
2101-4
Step 4: Printer: Cut Length
The following SPs are necessary for this step:
SP
1920-111 Cut Length Adjustment-1st Roll:297 mm (11" or 12"):Plain Paper
1920-115 Cut Length Adjustment-1st Roll:1189 mm (44" or 48"):Plain Paper
1920-211 Cut Length Adjustment-2nd Roll:297 mm (11" or 12"):Plain Paper
1920-215 Cut Length Adjustment-2nd Roll:1189 mm (44" or 48"):Plain Paper
• The cut length adjustment is done for all paper sizes after these settings are done.
• After these settings are done you may still need to do fine adjustments for each paper size.
1. Use the Preset Cut feature to make standard cuts of plain paper for these sizes:
Size
A3 Sideways
A1 Lengthways
A0 Lengthways
A Sideways (Eng. 11")
B Sideways (Eng. 17")
D Lengthways (Eng. 34")
E Lengthways (Eng. 44")
2. Measure the cuts and check them against the standards of this table.
Print Erase Margin – Leading Edge
2 Print Erase Margin – Trailing Edge
Print Erase Margin – Left Edge
0.5 Print Erase Margin – Right Edge
Orientation
Comments
SP Adjustments
3
185