Ricoh Neptune-P1 Service Manual page 210

919 D External controller error 6
While EAC (External Application Converter), the
conversion module, was operating normally, the
receipt of a power line interrupt signal from the
FLUTE serial driver was detected, or BREAK signal
from the other station was detected.
Printer error 1
920 B
An internal application error was
detected and operation cannot continue.
921 B Printer Error 2
When the printer application started, the
font designated for use could not be found
on the SD card.
954 D Printer Image Setting Error
The settings that are required for image
processing using the printer controller are
not sent from the IPU.
955 D Memory Setting Error
The settings that are required for image
processing using the memory are not sent
from the IPU.
965 D Print Start Error
During print processing, another command
to start printing was received.
• Controller RW3600 power
outtage
• Controller RW3600 rebooted
• Connection to Controller
RW3600 loose
• Software defective
• Turn the machine power off/on, or
change the controller firmware
• Insufficient memory
• The font is not on the SD card
• Firmware bug
• IPU defective
• Firmware bug
• Hard disk unit defective
• Controller defective
• MCU defective
• IPU defective
• Printer firmware defective
• Update printer firmware
SC Code Descriptions
4
209