Table of Contents
Advertisement
To install a toner cartridge
1. Set the toner cartridge [1] in the main machine.
2. Pull up the tape [2] then pull it across the toner cartridge from right to left to remove the tape.
3. On the right end of the toner cartridge, push the knob [3] up until it stops.
4. Close the toner hopper cover [4].
5. Switch the main power switch on.
Enter Developer Lot Numbers
• You must enter the lot numbers with SP2801-2 and -3 before doing SP2801-1. The main machine
will return an error ("Failed") if you attempt to do SP2801-1 before SP2801-2 and -3. The lot number
is embossed on the flap of the developer pack. If the lot numbers are the same, you must enter them
twice (SP2.801-2, SP2.801-3)
This example shows how to enter the lot number: 7C01203. Make sure that you enter the number on your
developer pack.
1. Press and hold down [] [] for at least 3 seconds.
2. Press [OK]
3. []>"Engine"> [OK]
4. []> "2. Drum"> [OK].
5. [] or []> "2.001"> [OK]
6. [] or []> "2.801"> [OK]
7. []> "2.801.2> [OK]
8. [String In]> [Text]
Main Machine Installation (G180)
1
33
Advertisement
Table of Contents
Troubleshooting
