Ricoh Neptune-P1 Service Manual page 71

1. Installation
• When you reattach the ground plate, confirm that no harness wires [3] below are pinched
between the bottom of the frame and bottom of the ground plate.
1
5. Reattach:
• Controller box cover
• Rear cover
• Open and close the paper exit cover C1 and paper exit unit C2 together to confirm that the rear
cover is installed correctly. If the paper exit cover does not open properly, remove the rear cover
and install it again.
6. Attach the decal [1] over the decal on the main machine..
70