Ricoh Neptune-P1 Service Manual page 349

5. Service Tables
to create shorter sections that will be covered by the top flap, so that the stack has a neat and uniform
appearance.
These adjusted folds can be done for either long folds or file folds as shown above.
• Stack [C] is a long fold (the first fold
flap is the same size as the other sections of the stack and long enough to cover the shorter adjusted
folds below.
• Stack [D] is a file fold (the first fold is a valley fold). The folds are adjusted at
is the same size as the other sections of the stack and long enough to cover the short adjusted folds
below.
1 FL:FP1
This SP determines the start of the first peak fold. To do this, it changes the timing of the fan fold
sensor (F) that affects how far the paper feeds past this sensor after the first peak fold. This
5 adjustment determines the length of a flap at the first fold wider than the succeeding folds.
[-70 to 70/0/0.1 mm]
Note:
• Adjustment in the "-" or "+" direction decreases or increases the amount of paper that feeds
past the sensor. This decreases or increases the length of paper between the first two folds.
2 FL:FV1
This SP determines the start of the first valley fold. To do this, it changes the timing of the fan fold
sensor (R) that affects how far the paper feeds past this sensor after the first peak fold. This
adjustment determines the length of a flap, starting at the leading edge, that is wider than the
succeeding folds. (This elongated flap can be used to bind the folded copy.)
[-70 to 70/0/0.1 mm]
Note: Adjustment in the "-" or "+" direction decreases or increases amount of paper that feeds
past the sensor. This decreases or increases the length of the paper (section) from the leading
edge to the first valley fold.
3 FL:FP2
This SP adjusts the operation of the fan fold sensor (F).
• If the first fold is a peak fold, this SP setting determines the length of even number sections,
excluding that of the first section.
• If the first fold is a valley fold, this SP setting determines the length of odd sections.
Note: Adjustment in the "-" or "+" direction decreases or increases amount of paper that feeds
past the sensor. This decreases or increases the length of the even or odd sections.
4 FL:FV2
348
is a peak fold). The folds are adjusted at
Fold Length: 1st Fold Peak
Fold Length: 1st Fold Valley
Fold Length: 2nd Fold Peak
Fold Length: 2nd Fold Valley
so that the last
so that the last flap