Ricoh Neptune-P1 Service Manual page 426

• The paper thickness can be set for the paper cassette and bypass tray only.
1. [Menu]
2. [] or []> "Maintenance"> [OK]
3. "General Settings"> [OK]
4. "Paper Thickness"> [OK]
5. [] or []> Select the target paper tray > [OK].
6. [] or []> Select the desired paper type> [OK]
• Plain Paper
• Recycled Paper
• Translucent Paper
• Film
7. [] or []> Select the desired position on the bar (from "Thick" to "Thin")
8. [OK]> "Programmed"
9. [Menu]> Standby
• These settings are used to adjust the fusing temperature and amount of pressure applied by the pressure
roller on the hot roller.
• Each notch (1 to 5) represents a "mode" (Mode 1 to Mode 5). These references to "modes" are used
in several SP codes below. Mode 1 is at the left end of the scale on the display, and Mode 5 is at the
right end.
• The modes for thicker paper are to the left of the "+" button and those for thinner paper to the right of
the "+" button.
• A thicker selection raises the fusing temperature and pressure applied by the pressure roller; a thinner
selection lowers the temperature and lowers the pressure for thinner paper.
• The settings can be done independently for paper fed from either the paper cassette or the bypass
tray.
Fusing Unit
6
425