Ricoh Neptune-P1 Service Manual page 77

1. Installation
• Set the level on the left bottom support
• Use a wrench to turn the nut on the leg at each corner under the machine to adjust the height.
• The machine should be level (front to rear) on both sides to within ±0.15 mm/m.
1
2. Push the folder unit [1] against the back of the machine [2].
3. Make sure that the folder is aligned properly with the back of the main machine.
• At the top and on both sides, make sure that upper positioning bracket
touching the back of the main machine
• At the right bottom side, make sure that the lower positioning bracket
the outer arm of the joint bracket
76
and then on the right bottom
. There must be no gap here.
of the main machine.
support.
of the folder unit is
of the folder is touching