Ricoh Neptune-P1 Service Manual page 265

5. Service Tables
9 Trans.: Mode4
10 Trans.: Mode5
11 Film: Mode1
12 Film: Mode2
13 Film: Mode3
14 Film: Mode4
15 Film: Mode5
16 Plain:Ltemp
5
1934 LTemp:HotRol
This SP sets the minimum difference in temperature allowed between the actual temperature
and the target temperature of the hot roller.
Important:
• Modes "1" to "5" below refer to the paper and thickness settings selected in User Tools
• The default setting of SP9952 should never be adjusted in the field.
1 Plain: Mode1
2 Plain: Mode2
3 Plain: Mode3
4 Plain: Mode4
5 Plain: Mode5
6 Trans.: Mode1
7 Trans.: Mode2
8 Trans.: Mode3
9 Trans.: Mode4
10 Trans.: Mode5
264
(see "Paper Thickness Default Selection" in this section). In order for this SP to operate,
SP9952 1 must be at "0" (default) so that the machine can acquire temperature readings
(feedback) from the pressure roller thermistors.
o
[60 to 80 /120/5 C]
Lower Limit Temperature: Hot Roller
[0 to 50/20/5]
[0 to 50/15/5]
[0 to 50/25/5]
[0 to 50/20/5]