Ricoh Neptune-P1 Service Manual page 290

51 LPH1-2SS<420
52 LPH2-3SS<420
2953 LPH J PwrAdj
Adjusts the four LEDs at each end of LPH 2. This fine adjustment is not usually necessary in the
field. DFU
[-63 to +63/0/1]
1 1-Dot: Left
2 2-Dot: Left
3 3-Dot: Left
4 4-Dot: Left
2954 BLineW:Prt
These SP's determine how line processing is handled for vertical lines.
Note: This SP has no effect on horizontal lines.
1 Change On/Off
This SP switches fine line processing by the LPH off and on.
[0 to 1/1/1]
0: Disabled
1: Enabled
10 Sel Lvl>2dot
This SP selects the level for fine line processing of vertical lines thicker than two dots.
[0 to 3/1/1]
0: Strongest processing (thinnest)
1: Normal processing
Adjusts sub scanning (SS) at LPH 1-2 for paper less
than 420 mm wide. This value is calculated
automatically. Do not adjust.
[-50 to +50/0/1] DFU
Adjusts sub scanning (SS) at LPH 2-3 for paper less
than 420 mm wide. This value is calculated
automatically. Do not adjust.
[-50 to +50/0/1] DFU
LPH Joint Power Corr
011 1-Dot: Right
012 2-Dot: Right
013 3-Dot: Right
014 4-Dot: Right
Binary Line Width Corr: Print
Level Select ( for > 2dots)
SP2-xxx Drum
5
289