Table of Contents
Advertisement
13. [] or []> "C"> [OK]
14. The remainder of the lot number consists of numbers, so toggle back to the numeric entry screen:
• [ABC/123]
• [] or []> "123"> [OK]
15. Enter the remaining digits of the number "01203".
• [] or []> To select the number> [OK]. Do this until all the numbers are entered.
• If you make a mistake, press the key below "Delete" to backspace and delete the previous number
to the left.
• After entering all the numbers, press the key below "Accept".
16. [Escape]> "2.801.002" (previous level).
17. []> "2.801.003"> [OK]
18. Repeat this procedure to enter the 2nd lot number.
Mix Developer and Initialize ID Sensor
1. Next, do SP2801-1 to mix the developer (and initialize the ID sensor). This takes about 5 minutes.
• To enter the SP mode press [] [] for at least 3 sec.> [OK]
• []> "Engine"> [OK]
Main Machine Installation (G180)
1
35
Advertisement
Table of Contents
Troubleshooting
