Ricoh Neptune-P1 Service Manual page 39

1. Installation
• Paper Size: Tray 2, Paper Type: Tray 2 (Roll 2)
• Paper Size: Tray 3, Paper Type: Tray 3 (Paper Cassette)
• Paper Size: Bypass, Paper Type Bypass (Bypass Tray)
1
10. [Menu]> Standby mode
Testing the Main Machine Circuit Breaker
• Follow the procedure below to test the operation of the circuit breaker. This must be done at installation
and at least once a year after installation.
1. Plug the main machine power cord into its power source and make sure that the main machine power
is off.
• Do not turn on the main machine. The main machine must be off.
2. Remove the rear cover [1] (x2)
3. Use the tip of a small screwdriver to depress the breaker test button.
• The breaker switch should flip from "|" to "O". This indicates that the breaker switch is operating
normally.
• If the breaker switch does not flip to "O", the switch must be replaced.
4. Push the breaker lever to display "|" again and reset the main machine for normal operation.
38