Ricoh Neptune-P1 Service Manual page 51

1. Installation
• Each plate is the same. It is not possible to install a plate in the incorrect position.
• Attach each plate with the ribbed side down.
• Move the hinges [2] a small distance apart. This allows the tabs attach easily into the holes.
1
19. Lift each plate and let it fall, to make sure that they move smoothly on the hinges.
20. Reattach the manual feed table.
21. Reattach the left and right covers.
• The flat-head screw must be attached at the rear side of each cover.
22. Close the upper unit.
Leveling the Main Machine and Attaching Leg Covers
1. Remove:
[1] Left small cover ( x 2)
[2] Left upper cover ( x 2)
[3] Right small cover ( x 2)
[4] Right upper cover ( x 2)
50