Ricoh Neptune-P1 Service Manual page 315

5. Service Tables
209 Instl Clear
Releases a machine from its embedded RCG setup.
250 Print Com Log
Prints the communication log.
5821 NRS Address (Japan Only)
5
1 CSS PI Device
2 RCG IP Address
NVRAM Upload
Uploads the UP and SP mode data (except for counters and the serial number) from
5824
NVRAM on the control board to a flash memory card.
While using this SP mode, always keep the front cover open. This prevents a software
module accessing the NVRAM during the upload.
NVRAM Download
5825
Downloads the content of a flash memory card to the NVRAM on the control board.
5828 Network Setting
This machine supports both Internet Protocols IPv4 and IPv6. IPv6 is the next generation
protocol designed by the IETF to replace IPV4. IPv6 adds many improvements such as routing
and network auto-configuration.
001 IPv4 Address
314
-2396 Device ID for Basil is illegal
-2397 Incorrect ID2 format
-2398 Incorrect request number format
Remote Service Address
Sets the PI device code. After changing this setting, you
must switch the machine off and on.
Sets the IP address of the RCG (Remote Communication
Gate) destination for call processing at the remote
service center.
[00000000h to FFFFFFFFh/ 00000000h]