Ricoh Neptune-P1 Service Manual page 63

1. Installation
1
1. Open the drawer of the roll feeder.
2. Remove the front cover [1] of the roll feeder ( x 3)
• If you cannot see the screw on the left or right side of the front cover, push the cutter [2] away
from the top of the screw.
3. Remove the knockout [3] ( x 2).
4. If Roll 2 is installed, remove it.
5. Remove the paper cassette from the paper cassette unit.
6. Remove the rear plate of the roll feeder ( x 2).
7. Put the cassette unit [1] in the roll feeder. The bosses must go through the holes in the flanges of the
cassette unit. Then, attach the cassette unit ( x 4).
62