Ricoh Neptune-P1 Service Manual page 57

1. Installation
Attaching the Wide Mylars to the Back of the Roll Feeder
1
1. On the left side of the rear plate [1], find the straight line [2] and ,
2. Use a clean cloth, moistened with a small amount of alcohol, to clean this area and the bottom edge
of the cover.
3. Remove the tape from each end of one of the wide mylars.
4. Align the end with the narrow tape with the top edge [4] of the rear plate. Make sure that the right
edge is parallel to the vertical lines on the plate, then push down.
5. Turn the end with the wide tape against the plate, and align its corner [5] with the inverted "L" pattern
embossed on the plate, then push it against the rear plate.
6. Make sure that the tape surfaces are pushed fully against the rear plate.
7. Reattach the rear cover of the main machine ( x 2).
56
patterns [3].