Ricoh Neptune-P1 Service Manual page 17

1. Installation
SP and User Tool Settings for Installation
Do all the SP and User Tool settings for the machine and installed options.
1

Final Installation
Complete the installation of the machine after you put it on the roll feeder and after you install all options.
Do some sample prints to check the operation of the machine and installed options.

MFP Options (Board/SD Card Options)
Install the MFP options and do a function check.

Folder Unit
Install the Folder Unit last. The MFP options must be installed before the folder unit because the folder
unit will block access to the board and SD card slots.
SP and User Tool Settings Required for Installation
This is a summary of the important SP and User Tool settings that are necessary for this installation.
Main Machine Installation
SP2801-2
SP2801-3
SP2801-1
SP2923-1
SP3001
[Menu]
Paper Size
Paper Type
16
Lot Number 1
Lot Number 2
Developer Initial Setting
Execute Cleaning Blade
Replace Mode
ID Sensor Initial Setting -
Initialization
[Menu]> "Paper Input"> "Paper
Size"/"Paper Type"> Tray n
Enter the toner lot numbers at installation before
doing SP2801-1
Mixes developer and initializes the ID sensor.
Applies a thin layer of toner to the drum. This
prevents scratches on the drum when the machine
power comes on for the first time.
Initializes the ID sensor after toner has been
applied to the drum.
Sets the paper size/paper type for each tray:
• Tray 1: Roll 1
• Tray 2: Roll 2
• Tray 3: Cassette
• Bypass