Ricoh Neptune-P1 Service Manual page 37

1. Installation
• [] or []> "2. Drum"> [OK]
• [] or []> "2.801.001"> [OK]> [Execute]
2. Do SP2923-001. This applies a thin layer of toner to the bare drum.
1
• [Escape]> [Escape]
• [] or []> "2.923.001"> [OK]> [Execute]
• Press [Escape] 3 times
• []> "End"> [OK]> Standby
3. Open the upper unit.
4. Push the cleaning-blade release lever [1] to the right.
• The cleaning-blade release lever keeps the cleaning blade away from the drum during
transportation. To prevent damage to the drum, before you move the main machine to a different
location, be sure to push this lever to the left.
5. Close the upper unit.
6. Do SP3001-2 to initialize the ID sensor again. Initialization takes about 15 sec.
• To enter the SP mode press [] [] for at least 3 sec.> [OK]
• []> "Engine"> [OK]
• [] or []> "3. Process"> [OK]
• [] or []> "3.001"> [OK]
• [] or []> "3.001.002"> [OK]> [Execute]
• The ID sensor must be initialized again after the cleaning blade has been lowered onto the drum.
7. Exit the SP mode and turn off the main power switch.
8. If you will install one or more of the following options, do these installations at this time:
36