Ricoh Neptune-P1 Service Manual page 306

This SP presents the screen used to enter the 11-digit number of the machine. The allowed
entries are "A" to "Z" and "0" to "9". The setting is done at the factory, and should not be
changed in the field.
Service TEL
Use these SP modes to input service and support telephone numbers. Enter the number and
5812
press
Press the  key to input a pause. Press the "Clear modes" key to delete the telephone
number.
1 Service
2 Facsimile
5816 NRS Function
I/F Setting
Turns the remote diagnostics off and on.
[0 to 2/1]
1
0: Remote diagnostics off.
1: Serial (CSS or @Remote) remote diagnostics on.
2: Network remote diagnostics on for @Remote
CE Call
2
Lets the operator engineer start or end of the remote machine check with CSS or @Remote;
to do this, push the center report key
Function Flag
Enables and disables remote diagnosis over the @Remote network.
3
[0 to 1/1]
0: Disables remote diagnosis over the network.
1: Enables remote diagnosis over the network.
SSL Disable
Controls if RCG (Remote Communication Gate) confirmation is done by SSL during an RCG
7
send for the @Remote over a network intersection.
[0 to 1/1]
Service representative telephone number.
Fax number of service representative
Service Tel. No. Setting
@Remote Service
SP5-xxx Mode
5
305