Ricoh Neptune-P1 Service Manual page 287

5. Service Tables
15 Re:Mod5:Ho
16 Re:Mod5:Ve
2923 CBlade Mode
Always do this SP after replacing the OPC or cleaning blade.
This SP applies a small amount of toner to the drum and blade to reduce friction between the
new drum and/or new blade. This prevents scratching the drum or bending the blade.
2924 Devr Mix
Enables/disables measurement of Vsg during warm-up immediately after the machine is
switched on. Vsg sampling is done to ensure good quality for the first copies.
5
[0 to 2/0/1]
0: Vsg is read immediately after the machine is switched on with the fusing temperature less
than 50°C (122°F).
1: Vsg is always read during warm-up immediately after the machine is switched on,
regardless of the fusing temperature level.
2: Vsg is not read during warm-up.
2925 TrCurr Tmg
These SP's adjust the transfer current timing.
1 ON
2 Leading Edge
3 Trailing Edge
2926 Tnr Over Det
The used toner bottle motor operates a cam. This cam strikes the side of the used toner collection
bottle, to create a vibration that levels the used toner inside the bottle.
1 Sn Detection
286
Recycled Paper: Mode5: Horiz
Recycled Paper: Mode5: Vert
Execute Cleaning Blade Replace Mode
Developer Mixing: Warmup
Transfer Current Timing DFU
Adjusts the timing for power on.
[0 to 16/6/0.2 mm]
Adjusts the timing for switching from the leading edge to the center.
[0 to 30/8/1 mm]
Adjusts the timing for switching from the center to the trailing edge.
[-30 to 0/0/1 mm]
Used Toner Overflow Detect
Used Tnr M (Sensor Detection)